Filter
Top Products
9
Setting up and connecting
SLB 450 A1
GB
IE
CY
Electrical connections
Before you connect up, compare the connection data (voltage and frequency) ■
on the plate of the appliance with that of your electrical network. This data
must match in order to avoid damage to the appliance.
Check to ensure that the power cable of the appliance is undamaged and it ■
will not be laid over hot surfaces and/or sharp edges.
Make sur
e that the power cable is not over taut or folded. ■
Do not let the power cable hang over edges (trip wire eff ect). ■
Inserting batteries into the remote control
NOTICE
The supplied battery (3V, type CR 2032) has already been fi tted into the ►
remote control at the factory. Before use, remove the insulation strip from
the battery compar
tment.
To insert a new battery, proceed as follows:
Open the battery compartment at the rear of the remote control
9
by
rotating the circular cover in the direction of the symbol
. Use a small
coin for turning it.
Insert a battery of the type CR 2032 (3V) into the battery compartment.
Make sure the polarities are correct; the positive pole faces up.
Close the battery compar
tment by replacing the round cover and turning it
in the direction of the symbol
until it is fi rmly seated back in the housing.
Fixing the air-bubble mat into the bath
DANGER
Slippery!
If the air bubble mat is not fi
xed into the bathtub properly,
there is a great risk of slipping!
Observe the following safety information to avoid the risks of slipping:
Carefully press the air-bubble mat onto the bottom of the bath tub until all ►
of the suction cups on the air-bubble mat are fi rmly secured to the bath
bottom.
Check ev
ery time before getting into the bath tub whether the air-bubble ►
mat is still properly and fi rmly secured.
Do not climb into the bathtub before all the suction cups of the air-bubble ►
mat are properly secured in the bath tub.