Filter
Top Products
10
Starting the Engine (continued)
Slide the ignition switch to the “I” 1.
(ON) position.
Starting A Flooded Engine
Slide ignition to OFF
OFF
Idle the engine briey before stopping
(about 2 minutes), then slide the igni-
tion switch to the “O” (Engine OFF)
position.
Stopping the Engine
NEVER operate the unit with the cut-
ting attachment shield or other protec-
tive devices removed!
Use only authorized Shindaiwa parts
and accessories with your Shindaiwa
edger. Do not make modications to
this unit without written approval from
Shindaiwa.
ALWAYS make sure the cutting attach-
ment is properly installed and rmly
tightened before operation.
Checking Unit Condition
NEVER use a cracked or warped cut-
ting attachment: replace it with a ser-
viceable one.
ALWAYS make sure the cutting attach-
ment ts properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could
damage the engine.
NEVER operate a unit with worn or
damaged fasteners or attachment
holders.
WARNING!
A cutting attachment shield
or other protective device is no
guarantee of protection against rico-
chet. YOU MUST ALWAYS GUARD
AGAINST FLYING DEBRIS!
Open the choke, put the throttle trig-2.
ger in the full throttle position, then
clear excess fuel from the com-
bustion chamber by cranking the
engine several times.
If the engine still fails to start or re, 3.
refer to the troubleshooting ow
chart at the end of this manual.