Filter
Top Products
7
4-6 mm
Adjust throttle lever free play
The throttle lever free play should be
approximately 4-6 mm. Make sure that
the throttle lever operates smoothly
without binding. If it becomes necessary
to adjust the lever free play, follow the
procedures and illustrations that follow.
Loosen the air cleaner cover knob 1.
and remove the air cleaner cover.
Loosen the lock nut on the cable 2.
adjuster.
Turn the cable adjuster in or out as 3.
required to obtain proper free play.
Tighten the locknut.4.
Reinstall the air cleaner cover.5.
Remove air cleaner cover
Throttle lever free play
Lock
Nut
Adjust as required to obtail 4-6 mm free play
Cable
Adjuster
Assembly (continued)
Cutting Attachment Shield
Insert the cutting attachment shield 1.
between the outer tube and the cut-
ting attachment mounting plate.
WARNING!
NEVER operate the unit
without the cutting attachment
shield installed and tightly secured!
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
head cap screws.
NOTE:
It may be necessary to loosen the
retaining nut and clamp screw to adjust
cutting attachment shield mounting
plate.
Fit the two spacers and the bracket 2.
over the outer tube and loosely
install the four socket-head screws.
Tighten the four socket-head cap 3.
screws to secure the cutting attach-
ment shield.
WARNING!
NEVER use this machine
without sub-shield when using a
trimmer head.
CAUTION!
Make sure the sub-shield is com-
pletely hooked at the hook receiver.
Sub-Shield (when trimmer head is in use)
Attach the shield extension to the cut-1.
ting attachment shield.
Sub-shield
Hook
Hook Receiver
Cutting Attachment Shield
Outer Tube
Socket-Head
Cap Screws
Retaining
Nut
Mounting Plate
Spacer
Spacer
Bracket
Cutting Attachment
Shield w/subshield
Attach the shield extension to the cutting
attachment shield
Cutting attachment shield assembly