Filter
Top Products
14
spark plug gap--all models
Remove the spark
plug and adjust the
gap at the electrode
10/15 hour maintenance
0.6 mm
(0.024 inch)
Remove and replace the fuel filter
element.
Use a hooked wire to extract the fuel ■
filter from inside the fuel tank. Inspect
the fuel filter element. If it shows signs
of contamination, replace with a genu-
ine Shindaiwa replacement fuel filter
element.
Fuel lter element
Hooked wire
50 hour maintenance
Maintenance (continued)
CAUTION!
Make sure you do not pierce the fuel
line with the end of the hooked wire.
The line is delicate and can be dam-
aged easily.
NOTE:
The NGK CMR5H also meets the
requirements for electro magnetic
compliance (EMC).
Replace the spark plug annually:
■
Use only NGK CMR5H or equiva-
lent resistor type spark plug of the
correct heat range. Set spark plug
electrode gap to 0.6 mm (0.024
inch).
CAUTION!
Before removing the spark plug,
clean the area around the plug to
prevent dirt and debris from getting
into the engine’s internal parts.
Remove and clean or replace the
spark plug.
Clean the spark plug. Adjust elec- ■
trode gap according to the values
listed in the ”Specifications” section.
If the spark plug must be replaced,
use only the type recommended in
”Specifications” or equivalent resis-
tor type spark plug of the correct
heat range.
Remove and inspect spark plug
Before reinstalling the new filter ■
element, inspect the condition of all
the fuel system components (fuel
pick-up line, fuel return line, tank
vent line, tank vent, fuel cap and fuel
tank).
If damage, splitting or deteriora-
■
tion is noted, the unit should be
removed from service until it can
be inspected or repaired by a Shin-
daiwa-trained service technician.