26
ENGLISH
storaGe
WARNING
During operation the mufer or catalytic mufer and surrounding cover become hot. Always keep exhaust area clear
of ammable debris during transportation or when storing, otherwise serious personal injury may result.
Long Term Storage (over 30 days)
Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage mainte-
nance which includes the following:
Store unit in a dry, dust free place, out of the reach of children.
WARNING
Hedge Trimmer blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades
whenever possible, and always wear gloves to protect hands.
DANGER
Do not store in enclosure where fuel fumes may accumulate or reach an open ame or spark, otherwise serious per-
sonal injury may result.
1.
Place the stop switch in the “OFF” position.
Remove accumulation of grease, oil, dirt and debris from
exterior of unit.
Perform all periodic lubrication and services that are
required.
Apply clean oil to the entire length of the blade. Be
certain the blade bolts are lubricated.
Install blade cover on blades.
Tighten all the screws and nuts.
Drain the fuel tank completely and pull the recoil starter
handle several times to remove fuel from the carburetor.
2.
3.
4.
5.
6.
7.
8.
Remove the spark plug and pour 7cc (1/4 oz.) of fresh,
clean, two-stroke engine oil into the cylinder through the
spark plug hole.
A. Place a clean cloth over the spark plug hole.
B. Pull the recoil starter handle 2-3 times to distribute
the oil inside the engine.
C. Observe the piston location through the spark
plug hole. Pull the recoil handle slowly until the
piston reaches the top of its travel and leave it there.
Install the spark plug (do not connect ignition cable).
9.
10.
IMPORTANT
Always store and transport hedge trimmers in a stable, horizontal position. Support gear case and cutting blades to
prevent excessive exing, which may cause damage to these components. Always install blade cover when transport-
ing or storing unit.