Filter
Top Products
4
WARNING!
Moving parts can amputate ngers or cause severe injuries. Keep hands, clothing and loose objects away
from all openings.
• ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
• DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
• NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
WARNING!
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause
unconsciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that
exhaust is directed away from your face and body.
Operating Precautions
WARNING!
Never transport the articulated ■
hedge trimmer or leave it unat-
tended with the engine running.
An engine that’s running could be
accidently accelerated causing the
blades to oscillate.
Make sure that the blade cover is in
■
place when transporting or storing
the articulated hedge trimmer.
Always make sure that the cut-
■
ter attachment and all handles and
guards are properly installed and
rmly tightened before operation.
Inspect for broken, missing or
■
improperly installed parts or
attachments.
Never use a cracked or warped cut-
■
ter or cutter bar: replace it with a
serviceable one and make sure it
ts properly.
Make sure there are no missing or ■
loose fasteners, and that the stop
switch and throttle controls are work-
ing properly.
Make sure there is always good ■
ventilation when operating the artic-
ulated hedge trimmer. Fumes from
engine exhaust can cause seri-
ous injury or death. Never run the
engine indoors!
Never smoke or light res near the
■
hedge trimmer. Keep the unit away
from excessive heat. Engine fuel is
very ammable and re could lead
to serious personal injury or prop-
erty damage.
Make sure the cutters are cor-
■
rectly adjusted before operating the
articulated hedge trimmer (see the
section ”Cutter Blade Adjustment”
for cutter adjustment procedures).
Never attempt cutter adjustment
with the engine running!
Before starting the engine, make
■
sure the cutter is not contacting
anything.
Always conrm safe operation
■
when using the machine.
Immediately stop the engine with
■
the stop switch if the machine sud-
denly begins to vibrate or shake.
Always stop the engine imme-
■
diately and check for damage if
you strike a foreign object or if the
machine becomes tangled. Do not
operate with broken or damaged
equipment.
When cutting a branch that is
■
under tension, be alert for spring-
back so that you will not be struck
by the moving branch.
If a cutter should bind fast in a cut,
■
shut off the engine immediately.
Push the branch or tree to ease
the bind and free the cutter.
Always stop the engine and allow
■
it to cool before refueling. Avoid
overlling and wipe off any fuel
that may have spilled.
To reduce re hazard, keep the
■
engine and mufer free of debris,
leaves, or excessive grease.
Keep a Solid Stance. Maintain
■
footing and balance at all times.
Do not stand on slippery, uneven
or unstable surfaces. Do not work
in odd positions or on ladders. Do
not over reach.
WARNING!
Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching
blades whenever possible, and always wear gloves to protect hands