Filter
Top Products
3
WARNING!
n Never transport the articulated
hedge trimmer nor set it down with
the engine running. An engine that’s
running could be accidently acceler-
ated causing the blades to oscillate.
n Make sure the cover is in place
when transporting the articulated
hedge trimmer.
n When carrying the articulated hedge
trimmer by hand, the cutter attach-
ment should be pointing backward
with the cutter blade in the retracted
or transporting position (see page 7
for articulating adjustment proce-
dures).
n Always make sure the cutter attach-
ment is properly installed and rmly
tightened before operation.
n Never use a cracked or warped
cutter or cutter bar: replace it with
a serviceable one and make sure it
ts properly.
n Before starting the engine, make
sure the cutter is not contacting
anything.
n Always stop the engine immediately
and check for damage if you strike
a foreign object or if the machine
becomes tangled. Do not operate
with broken or damaged equipment.
n When cutting a branch that is under
tension, be alert for spring-back so
that you will not be struck by the
moving branch.
n Stop the machine immediately if it
suddenly begins to vibrate or shake.
Inspect for broken, missing or
improperly installed parts or attach-
ments.
n Do not operate the articulated
hedge trimmer with the mufer
removed.
n Always stop the engine and allow
it to cool before refueling. Avoid
overlling and wipe off any fuel that
may have spilled.
n Make sure there is always good
ventilation when operating the
articulated hedge trimmer. Fumes
from engine exhaust can cause
serious injury or death. Never run
the engine indoors!
n Never smoke or light res near the
hedge trimmer. Keep the trimmer
away from excessive heat. Engine
fuel is very ammable and re could
lead to serious personal injury or
property damage.
n Make sure there are no missing or
loose fasteners, and that the stop
switch and throttle controls are
working properly.
n If a cutter should bind fast in a cut,
shut off the engine immediately.
Push the branch or tree to ease the
bind and free the cutter.
n Make sure the cutters are correctly
adjusted before operating the articu-
lated hedge trimmer (see page 12
for cutter adjustment procedures).
Never attempt cutter adjustment
with the engine running!
Figure 1
IMPORTANT!
Caution, Danger, Warning, and
Operation Information Labels:
Make sure all information labels are
undamaged and readable. Immedi-
ately replace damaged or missing
information labels. New labels are
available from your local authorized
Shindaiwa dealer.
Safety Equipment and Labels
High Voltage Label
Cutter Blade
Scabbard
Hand
Guard
Shaft
Safety Label
Throttle
Interlock
Stop
Switch
Operating Precautions