20
ENGLISH
eXhaust system
Spark Arrestor Screen
Level 2.
Tools required: 3 mm Hex wrench, Cross Head Screwdriver, Soft
metal brush
Parts required: Screen, Gasket
Remove engine cover. See “Cleaning Cooling System” for step by step
instructions.
Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
Remove exhaust guide (A), gasket (B), and screen (C) from mufer body.
Clean carbon deposits from mufer components.
NOTE
When cleaning carbon deposits, be careful not to damage the cata-
lytic element inside mufer.
Replace screen if it is cracked, plugged or has holes burned through.
Assemble components in reverse order.
NOTE
When installing the cylinder cover, be certain the mufer gasket
tabs (D) are locked into the mufer grill slots and the stop switch
lead is seated in the rubber grommet.
1.
2.
3.
4.
5.
6.
D
A
B
C
Cylinder Exhaust Port
Level 3.
IMPORTANT
The cylinder exhaust port must be inspected and cleaned of excess
carbon every 3 months or 90 hours of operation in order to main-
tain this engine within the emissions durability period. Shindaiwa
strongly recommends that you return your unit to your Shindaiwa
dealer for this important maintenance service.