Shindaiwa 81010 Trimmer User Manual


 
11
27029
Starting the Engine (continued)
WARNING!
Never start the engine from the
operating position.
WARNING!
The cutting attachment may rotate
when the engine is started!
When the Engine Starts...
After the engine starts, allow the engine
to warm up at idle 2 or 3 minutes before
operating the unit.
After the engine is warm, pick up the
unit and clip on the shoulder strap or
harness if so equipped. See page 12.
Advancing the throttle makes the cut-
ting attachment turn faster; releasing
the throttle permits the attachment to
stop turning. If the cutting attachment
continues to rotate when the engine
returns to idle, carburetor idle speed
should be adjusted (see below).
IMPORTANT!
If the engine fails to start after several
attempts with the choke in the closed posi-
tion, the engine may be flooded with fuel.
If flooding is suspected, move the choke
lever to the open position and repeatedly
pull the recoil starter to remove excess
fuel and start the engine. If the engine still
fails to start, refer to the troubleshooting
section of this manual.
6. When the engine starts, slowly move the
choke lever to the “OPEN” position. See
Figure 19. (If the engine stops after the
initial start, close the choke and restart.)
Figure 19
Idle the engine briefly before stopping
(about 2 minutes), then slide the ignition
switch to the “O” (OFF) position.
See Figure 20.
Stopping the Engine
T272/T272X
IGNITION SWITCH OFF
Figure 20
7. Operating the throttle will automatically
disengage the fast idle setting.
Choke Control
(open position)
Engine Idle Adjustment
The engine must return to idle speed
whenever the throttle lever is released.
Idle speed is adjustable, and must be set
low enough to permit the engine clutch to
disengage the cutting attachment when the
throttle is released.
Idle Speed Adjustment
WARNING!
The cutting attachment must NEVER
rotate at engine idle! If the idle speed
cannot be adjusted by the procedure
described here, have the unit inspected
at an authorized Shindaiwa dealer.
1. Place the unit on the ground, then start
the engine and allow it to idle for 2-3
minutes until warm.
Figure 21
Idle
Adjusting Screw
2. If the attachment rotates when the
engine is at idle, reduce the idle speed
by turning the idle adjustment screw
counter-clockwise. See Figure 21.
3. If a tachometer is available, the engine
idle speed should be final adjusted to
3,000 (±250) RPM (min
-1
).
NOTE:
Carburetor fuel mixture adjustments are pre
-
set at factory on units with emission control
systems and cannot be serviced in the field.
IGNITION
SWITCH
OFF