Filter
Top Products
OPERATION
EC72 03/08 Operation Section 4-10
© 2008 Alamo Group Inc.
OPERATION
Note: Offset Adaptor Hitches are available to position the mower to the left or right. Mowers with Offset
Adaptor hitches connect to the 3-Point hitch the same way as the mower A-frame. Mowers with Cat 1 Hitch will
be offset approximately 13” with the use of this accessory. See Offset Hitch in the Assembly Section for details
to equip the mower with this feature.
6.2 Safety Chains
When towing implements on a public roadway, use a safety chain with tensile strength equal to or greater than
the gross weight of the unit being towed. This will control the implement in the event the hitch pin is lost during
transport.
After the ends of the safety chain are attached to the implement and the tractor, make a trial run by driving the
tractor to the right and to the left to check for proper length. If necessary readjust the chain to eliminate loose or
tight chain lengths.
7.1 Setting Mower Height- Lift Type - (Standard or Quick Hitch)
1. Park the tractor and mower on level ground.
2. Using the 3-point hitch control lever, position
the front of the mower with the side skids 1”
less off the ground than desired cut height. For
example, for a 3” cut, position the skids 2” from
the ground. Set the 3-point control lever stop at
this position to maintain this height when
raising and lowering the mower.
3. Shut down the tractor and remove the key.
4. Adjust the mower deck front to rear by
extending or retracting the 3-point top link.
Always set front of deck 3/4” lower than rear for
best performance.
7. SETTING THE MOWER
Properly setting the cutting height is essential for efficient and safe operation. A properly set mower will make
a more uniform cut, distribute clippings more evenly, require minimal tractor work, and follow the contour of
uneven terrain. NOTE: Avoid very low cutting heights, striking the ground with the blades gives the most
damaging shock loads and will cause damage to the mower and drive. Blades contacting the ground may
cause objects to be thrown out from under the mower deck. Always avoid operating the mower at a height
which causes the blades to contact the ground. OPS-U- 0010
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)