Filter
Top Products
ASSEMBLY
EC72 03/08 Assembly Section 3-2
© 2008 Alamo Group Inc.
ASSEMBLY
DEALER SETUP INSTRUCTIONS
Set up mower as received from factory with these instructions.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware. Refer to bolt torque chart in Maintenance Section. All bolts are Grade 5
unless otherwise specified.
1. Position on flat surface.
2. Apply light oil to gear box input shaft.
SHIELD ASSEMBLY
Before installing gearbox shields, check lubricant level in gearbox. Refer to Maintenance Section - Gearbox.
Attach cotter pin and cable assembly (3) through top shield bracket (2) from outside in. Remove the bolts (4) on
the front of the gearbox housing. Align holes in the top shield bracket (2) and gearbox. Reinstall the bolts and
lockwasher (Torque to 33 ft. lbs.). Attach cotter pin (3) through top shield (1) from outside in. Attach shield (1) to
top bracket (2) and secure with flatwasher (5) and nut (6). Figure AsmP-R-0068 & 0069