Servis-Rhino DM112 Lawn Mower User Manual


 
MAINTENANCE
DM 07-02
Maintenance Section 5-7
© 2004 Alamo Group Inc.
To prepare your Disc Mower for storage:
1. Clean the mower of all dirt and debris.
2. Drain the oil from the cutter bar and replace with fresh SAE HD90 lube oil. (See Lubrication Instructions.)
3. Store the mower on a clean, dry surface in the down (working) position.
4. Loosen the drive belts or remove the belts and store in a dry place.
5. Lubricate all points and slides before storage. This prevents corrosion.
NOTE: Now would be a good time to replace all damaged parts in preparation for the next cutting season.
Storage
Troubleshooting
Problem Probable Cause Solution
Does not cut properly Dull Blades Replace Blades
Worn or broken blades Replace Blade Set
Ground speed too fast Reduce ground speed
Blades do not turn when Check belt tension.
PTO is running Check for broken drive parts.
Improper belt tension Adjust Belt Tension
Streaks or gives ragged out Broken or worn blades Replace or sharpen blades
Ground speed too fast Reduce ground speed
Excessive cutting height Lower cutting height by tilting bar forward
(Note: Set height so blades do not
hit ground)
Dirt build up between rock Clean bar area between rock guard at
guards leading edge
Reversed blade direction Check to see if blades are installed
correctly with the cutting edge in
correctposition
Improper belt tension Adjust belt tension
Thrown objects Improper shielding Replace cover
Cutting too close to ground Raise cutting height
Excessive clutch slippage Clutch discs worn Replace discs
Blades hitting ground Raise cutting height by tilting rearward
Wrapping around disc Remove any material wrapped around disc
Optional Equipment
Category I Hitch Pin (Part No. 3220403) for DM82 or DM95.
Spring Assit Kit (Part No. 3220400 for Model DM112.
NEVER DISCONNECT MOWER FROM TRACTOR WITHOUT CUTTER BAR IN LOWERED
TO (OPERATING) POSITION.
CAUTION!