Filter
Top Products
ASSEMBLY
DM 07-02
© 2004 Alamo Group Inc.
Assembly Section 3-4
9. Place the cover sheet over the assembled frame and secure the sheet in place with plastic ties through
grommets around cover frame at all locations. (See Figure 7.) DO NOT OVERTIGHTEN PLASTIC TIE.
10. Attach the hydraulic cylinder and Lift Rod (K) to the main frame and link attached to the cover frame. Use
a lift rod pin, capscrew and lockwasher. To secure the lift rod to the link and a cylinder pin and cotter keys to
secure the cylinder to the main frame yoke. (See Figure 8.)
Figure 7
11. Attach the Inner Shoe (L) to the cutter bar (See Figure 9) using the hardware shown in the parts list.
12. Install the Inner Swath Board (M) on the cutter bar (See Figure 10) using the hardware shown in the
parts list.
Figure 9 Figure 10
Figure 8
13. Install the Swath Board Bracket (N) beneath the end of the cutter bar as shown in Figure 12 using the
hardware shown in the parts list. If the swath board is not installed, install it in the swath board bracket at
this time.