Filter
Top Products
ASSEMBLY
STEP 6
(this operation shall be performed by two operators). Lift the three point linkage and mount it on the machine as
shown in the Picture.
An operator must keep the three point linkage in this position until the safety release device is mounted.
STEP 7. Remove partially the pin of the “end-winding cover of the three point” and the lock pin (Picture 7.1). Remove the
two pins of the cover, one on each side (Picture 7.2). Insert the “end-winding cover of the three point” on the machine
(Picture 7.3).
Picture 7.1 Picture 7.2. Picture 7.3
STEP 8. Mount the two cover locking pins.
ASSEMBLY
AGM 52-62-72-82
10/10
Assembly Section 3-7
© 2010 Alamo Group Inc.