Sears C459.627020 Cultivator User Manual


 
7
ASSEMBLY INSTRUCTIONS
USING THE CORD RETAINER
There is an extension cord re tainer to prevent the extension cord
from disconnecting during use. The retainer hangs from the cord
guide bar.
NOTE: Do not plug the extension cord into the power source
receptacle until the cord is connected to the cord retainer
and plugged into the unit.
To use the cord retainer:
1. Fold the extension cord in half, forming a tight loop near the
receptacle.
2. Push the loop through the bottom hole in the retainer (Fig. 3).
Fig. 3
Fig. 4
Fig. 5
3. Slide the loop over the retaining clip and pull down until the
cord fits snugly (Fig. 4).
NOTE: Use a UL-approved extension cord. A 100-foot, 14-gauge
cord is recommended. A 50-foot, 16-gauge cord is
acceptable.
The cord retainer keeps the extension cord safely to the side of the
operator by sliding to the left and right on the guide bar as the unit
is moved. Connect your extension cord to the unit as shown in
Figure 5.