Filter
Top Products
GASOLINE
FILLER
CHOKE"
CON-
TROL
OPERATI
ELECTRIC
START BUTTON
RECOIL
_UXlLIAR_
STARTER
HANDLE
AUGER DRIVE DISCHARGE
CONTROL SPEED CHUTE
LEVER CONTROL CONTROL
LEVER LEVER
CHUTE
DEFLECTOR
DEFLECTOR
REMOTE
CONTROL
LEVER
TRACTION
DRIVE
CONTROL
LEVER
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
NOTE: iTEMS ABOVE
ARE SHOWN iN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WiTH THE
ENGINE ON YOUR
UNIT.
\
DISCHARGE
CHUTE
CLEAN-OUT
TOOL
HANDLE
KNOB
MUFFLER
TOOLBOX
PLATE
AUGERS
FIG. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, Iocknuts and
wrench.
Safety ignition key = must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Primer =pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
10
ON / OFF switch =used to STOP the engine.
Choke control - used for starting a cold engine.
Traction drive control lever - used to engage power-
propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Deflector remote control lever =used to change the di-
stance the snow is thrown.
Discharge chute control lever - used to change the direc-
tion the snow isthrown.
Skid plate - used to adjust height of scraper bar from the
ground.