Filter
Top Products
1-1/4"
(rear wheel only)
Mower housing
Shoulder
bolt
3/8-16
Wheel Locknut
ASSEMBLE DISCHARGE GUARD
1. Place discharge guard on top of lawn
mower discharge opening.
2. Install two (2) 1/4-20 x 3/4 hex bolts
through housing and discharge guard,
3. Install two (2) 3/4" diameter washers
and two (2) 1/4-20 Iocknuts. Tighten
securely.
Locknut.=
Washers
Discharge guard
ASSEMBLE ENGINE ZONE CONTROL
CABLE TO ENGINE
Cable attaches under brake arm cover,
(opposite side of engine as spark plug).
1. Straighten cable and find the end with
the small plastic fitting.
2. Hook "Z" bend fitting on inner wire of
cable into hole in brake arm of engine.
3. Align tapered end of small plastic
fitting with hole in mounting bracket
and push until fitting snaps into place.
bracket
Small plastic Brake
fitting arm
ASSEMBLE ENGINE ZONE CONTROL
CABLE TO UPPER HANDLE
Attach cable opposite upstop bracket.
1. Route cable below crossbar of lower
handle and up to control bar.
2. Hook "Z" bend fitting on inner wire into
hole in control bar.
3. Attach cable fitting to upper handle.
4. Secure cable to lower handle with
wire tie.
bar
Upper
Up-stop
bracket
Hex
INSTALL CONTROL BAR
1. Position control bar so flattened
section with hole is on opposite side
of handle as up-stop bracket.
2. Insert one end of control bar into
handle hole on inside of handle.
Carefully push in on opposite end of
control bar and insert into hole on
opposite side of handle.
zone
control
cable
INSTALL STARTER ROPE
1. Put threaded end of rope guide
through hole in side of upper handle
above lower handle crossbar. Secure
with 1/4-20 Iocknut.
2. Hold control bar against upper handle
and slowly pull engine starter rope out
until it will slip into loop of rope guide.
Upper
Rope
Engine
,p bracket 7 starter rope