Filter
Top Products
TROUBLE SHOOTING GUIDE
PROBLEM
=, __J
1, Doesn't draw
chemioalldeter.
gent like it
should
,,,,,,
2. Sputters when
spraying
chemical/
detergent
3. Not enough
spray force
, ,,,_ LJ,L
4. Chemical/deter-
gent doesn't
combine with
water pressure
inside of power
washer
L, ,,!
CAUSE
LI= ,_
. Chemical control knob not open far
enough or too far open
,, Chemical/detergent not thinned
enough
. Chemicalldetergent not proper type
for suction use.
q Water control knob "ON"
ii ii •
• Chemical control knob open too far
LLI
Water and/or air pressure too low
= Water and air control knobs not fully
CORRECTION
, ,,_,,
• Open knob gradually untilyou
achieve desired flow rate (2_ turns
maximum)
• Add water to thin the solution
• Use Sears speoial oleanerldegreaser
• Turn water control knob"OFF" Only
air and chemical Control knobs
should be "ON"
Ju_,uu
• Close knob until sputter stops
1
J,, _ LJ,,, _J,,,J,L
* Use Maximum water and air pres-
sure available (not to exceed 175
psig)
. Open both knobs fully
open
* Surface heavily soiled
• Scrub surface with rag or sponge to
loosen dirt then rinse with air and
water control knobs "ON"
,,1, ,, i J,
• Power Washer is not designed to do
this
• To Wash or spray chemically usa
chemical and air control knobs ON
only. To Rfnse, use water and air
control knobs ON only.
10