Filter
Top Products
ii i , Ill ',l,,I "1 ' ,",,,i,,
ADJUSTMENTS
................ illll
WITH PARKING BRAKE "ENGAGED"
SERVICE AN
i iml,i i
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 25)
The mower blade drive belt may be replaced without tools.
Park the tractor on level surface° Engage parking brake_,
BELT REMOVAL -
• Remove tractor from mower (See "TO REMOVE
MOWER" in this section of this manual).
• Work belt off both mandrel pulleys and idler pulley,
• Pull belt away from mower,
BELT INSTALLATION -
• Install new belt in reverse order of removal.
- Make sure belt is in all pultey grooves and inside all belt
guides.
, \
MANDREL
PU LLEY
MANDREL IDLER
PULLEY
FIG. 25
NUT "A"
JAM NUT
,/
OPERATING
ARM
FIGo 26
TO ADJUST BRAKE (See Fig. 26)
Your tractor is equipped with an adjustable brake system
which is mounted on the right side of the transaxle.
Iftractor requires more than six (6) feet stopping distance
at high speed inhighest gear, then brake must be adjusted.
° Depress clutch/brake pedal and engage parking brake
. Measure distance between brake operating arm and
nut "A" on brake rod
- If distance is other than 1-1/2", loosen jam nut and turn
nut "A" until distance becomes 1-1/2", Retighten jam
nut against nut "A",
o Road test tractor for proper stopping distance as stated
above Readjust if necessary, If stopping distance is
still greater than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au-
thorized service center/department
TO REPLACE MOTION DRIVE BELT
(See Fig. 27)
Park the tractor on level surface, Engage parking brake,
For assistance, there is a belt installation guide decal on
bottom side of left footrest,
- Remove mower (See 'q'O REMOVE MOWER" in this
section of this manual )
o Remove upper belt keeper.
. Remove belt from stationary idler and clutching idler
. Pull belt slack toward rear of tractor, Remove belt
upwards from transaxte pulley by deflecting belt keep-
ers.
', Pull belt toward front of tractor and remove downwards
from around engine pulley
° Install new belt by reversing above procedure.,
IMPORTANT: MAKE SURE UPPER BELT KEEPER IS
POSITIONED PROPERLY BETWEEN LOCATOR TABS
ENGINE
PULLEY
CLUTCHING
IDLER
STATIONARY
IDLER
TRANSAXLE
PULLEY
_ II KEEPER
FIG. 27
21