Filter
Top Products
ICE AND ADJUSTMENTS
TO REPLACE HEADLIGHT BULB
• Raise hood
° Pull bulb holder out of the hole in the backside of the
grill
. Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the gdtL
• Close hood
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
pooriy, stop running,or prevent it from starting
• Check wiring See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse The
fuse holder is located behind the dash
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)
. Raise hood
• Unsnap headlight wire connecter.
• Stand in front of tractor Grasp hood at sides, tilt toward
engine and lift off of tractor
- To replace, reverse above procedures
HOOD
HEADLIGHT
WIRE
CONNECTOR
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 31)
The throttle controt has been preset at the factory and
adjustment should notbe necessary. Checkadjustmentas
described below before loosening cable,, Ifadjustment is
necessary, proceed as follows:
• With engine not running, move throttle control lever
from slow (.,l) to choke (t\0 position Slowly move
lever from choke (l\l) to fast (._) position
• Check that holes 'W' ingovernor control lever and hole
in governor plate line-up If holes "A" are not aligned,
loosen clamp screw and move throttlecable until holes
are aligned T_ghten clamp screw securely
GOVERNOR GOVERNOR
CONTROL LEVER CONTROL PLATE
HOLES "A"
CLAMP THROTTLE
SCREW CABLE
FIG. 31
FIG. 30
24