Filter
Top Products
ASSEMBLY
INSTALL MULCHER PLATE
(See Figs. 6 & 7)
° install two latch hooks to mulcher plate using screw,
washer, lock washer, and weld nut as shown.
NOTE: Pre-assemble weld nut to latch hook by inserting
weld nut from the top with hook pointing down°
° Tighten hardware securely°
° Raise and hold deflector shield in upright position.
° Place front of mutcher plate over front of mower deck
opening and slide into place, as shown_
Hook front latch into hole on front of mower deck_
°
i
Hook rear latch into hole on back of mower deck..
........ - • i i i i i ii i i i i,lllllllllillllllll
CAUTION: Do not remove discharge
guard from mower, Raise and hold
guard when attaching mulcher plate
and allow it to rest on plate whde in
operation.
..... ,,, ,,_...................
WELD NUT FROM THE TOP HOOK POINTS DOWN
LOCK
WELD WASHER
LATCH
SCREW
LATCH
ROOK
WASHER
LOCK
WASHER
WASHER
WELD
NUT
MULCHER
PLATE
FIG. 6
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in a safe place.
Your mower is now ready for discharging or installation of
optional grass catche[ accessory_
DEFLECTOR
LATCH
HOOKS
FIG. 7
,/'CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE
THEBEST PERFORMANCE AND SATISFACTION FROM
THIS QUALITY PRODUCT
PLEASE REVIEW THE FOLLOWING CHECKLIST:
/ All assembly instructionshave been completed.
v" No remaining loose parts in carton.,
/ Battery is properly prepared and charged. (Minimum
1 hour at 6 amps).
Seat is adjusted comfortably and tightened securely.
,/ Ait tires are properlyinflated. (For shipping purposes,
the tires were overinflated at the factory).
,/ Be sure mower deck is properly leveled side-to-side/
front-to-rear for best cutting results. (Tires must be
properly inflated for levefing).
,/ Check mower and drive belts. Be sure they are routed
properly around pulleys and inside all belt keepers.
,/ Check wiring. See that all connections are still secure
and wires are properly clamped.
WHILE LEARNING HOWTO USE YOUR TRACTOR, PAY
EXTRA A TTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
/ Engine oil is at proper level.
,/ Fuel tank is filled with fresh, clean, regular unleaded
gasoline_
,/ Become familiar with all controls - their location and
function,. Operate them before you start the engine..
,/ Be sure brake system is in safe operating condition.
10