Filter
Top Products
ill i ............................. illl ,,i,i ii.......................
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 38)
• Raise hood,.
• Unsnap headlight wire connector,.
° Stand in front of tractor, Grasp hood at sides, tilt toward
engine and lift off of tractor.
° To replace, reverse above procedure.
WIRE
CONNECTION
FIG. 38
HOOD
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 39)
The throttle control has been preset at the factory and
adjustment should notbe necessary, Check adjustment as
described below before loosening cable,, if adjustment is
necessary, proceed as follows:
• With engine not running, move throttle control lever to
"FAST" position.,
° Check that swivel is against side of quarter circle. If it
is not, loosen cable clamp screw and pull cable back
until swivel is against quarter' circle° Tighten cable
clamp screw securely.,
............... i iiil,,ll ii i iilllllllllllllll i
ADJUSTMENTS
Hi,uui lllllllll i t
QUARTER _ "s_ \ \ )
FIG. 39
CHOKECLOSED
CASING
CLAMP
SCREW
CHOKE
LEVER
FIG. 40
TO ADJUST CHOKE CONTROL (See Fig. 40)
The choke control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, _proceed as follows:
° With engine not running, move choke control (located
on dash panel) to full "CHOKE" position°
° Remove air cleaner cover, filter and spitback plate to
expose carburetor choke (see "AIR FILTER" in main-
tenance section).
° Choke should be closed. If it is not, loosen casing
clamp screw and move choke cable until choke is
completely closed, Tighten casing clamp screw se-
curely.
° Reassemble air cleaner.
24