Filter
Top Products
SE CE USTM NTS
with plug.
TO REMOVE MOWER (See Fig. 19)
,, Place attachment clutch in "DISENGAGED" position.
= Turn height adjustment knob to lowest setting.
Lower mower to its lowest position.
Remove retainer spring holding anti-swaybar to chas-
sis bracket and disengage anti-swaybar from bracket.
- Remove retainer springs from suspension arms at
deck and disengage arms from deck.
= Raise attachment lift to its highest position.
• Remove two retainer springs from each front link and
remove links.
- Slide mower forward and remove belt from electric
clutch pulley.
= Slide mower out from under right side of tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
TO INSTALL MOWER
Follow procedure described in "INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual•
ADJUSTMENT
NUTS
SUSPENSION
ARMS
CHASSIS
LiFT FRONT
LINKS SUSPENSION
BRACKET
BRACKET
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See
"PRODUCT SPEC tFICATIQNS" on page 3 of this manual).
Iftires are over or underinfiated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)
, Raise mower to its highest position.
• Measure height from bottom of deck curl to ground
level at front corners of mower. Distance "A" on both
sides of mower should be the same.
• If adjustment is necessary, make adjustment on one
side of mower only.
- To raise one side of mower, tighten lift link adjustment
nut on that side.
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Each fun turn of adjustment nut will change mower
height about 3/16",
Recheck measurements after adjusting.
BOTTOM BOTTOM
OFCURL OFCURL
RETAINER
SPRING
RETAINER
NGS
FRONT
SUSPENSION
BRACKET
ANTI-SWAY
BAR RETAINER
SPRINGS
\
\
BRACKET
FIG. 19
2O