Filter
Top Products
1
#7600058 TRANSMISSION PULLEY KIT FOR
SEARS / SIMPLICITY ZT RIDING MOWERS
WARNING
DO NOT attempt any adjustments, maintenance, repairs, or service with engine running. Stop engine. Engage
parking brake. Remove key. Remove spark plug wire and secure wire away from spark plug. Engine, muffler and
surrounding areas are extremely hot. Avoid serious burns; allow components to cool down before installing kit.
Replace worn or damaged parts prior to operating. Use approved fuel container. DO NOT smoke near open fuel
container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes
before refilling. Make sure that fuel cap is tightened securely. Wipe off any spilled fuel before starting engine.
!
STEP 1: Lower the mowing deck to its lowest cutting posi-
tion. Refer to the unit’s Operator’s Manual for instructions.
STEP 2: Remove the mowing deck belt from the electric
clutch pulley. Refer to the unit’s Operator’s Manual for
instructions.
STEP 3: Carefully cut the wire tie securing the electric clutch
harness to the clutch retainer. Then disconnect the electric
clutch harness from the unit’s main electric harness. See
Figure 1.
STEP 4: Remove the hardware securing the electric clutch
to the engine shaft. Remove the clutch and clutch key from
the engine shaft. See Figure 1.
STEP 5: Remove the forward end of the transmission idler
spring from the shoulder bolt mounted to the underside of
the unit. See Figure 2.
STEP 6: Remove the transmission belt from the engine
pulley and the two transmission pulleys. See Figure 3.
Note: The transmission belt is retained in the idler assembly
by the idler belt guide, and therefore cannot be removed
from the idler assembly at this time.
STEP 7: Remove the engine pulley assembly from the
engine shaft, and replace with the engine pulley assembly
supplied with this kit. See Figure 3.
!
FIGURE 1
Disconnect harness
Remove hardware and clutch
FIGURE 2
Remove idler spring end
FIGURE 3
Remove
belt
Replace with
supplied
engine pulley
INSTRUCTION No. 7101803 (I.R. 10/31/2007)
TP 200-5303-IR-AT-SC
Kit Contents - 7600058 Transmission Pulley Kit
7027266 - 7/16-20 x 3 Hex Head Cap Screw (1)
7101716 - Engine Pulley (1)
7101717 - Clutch Retainer (1)
1732224 - Transmission Belt (1)
7072080 - Wire Tie (1)