Filter
Top Products
Change Oil
While engine is still warm, drain oil from crankcase.
Refill with recommended grade. See "Changing Oil" on
page 12.
Oil Cylinder Bore
• Remove spark plug. Squirt about 1 ounce of clean
engine oil into the cylinder. Cover spark plug hole
with rag. Pull recoil handle slowly to distribute oil.
Avoid spray from spark plug hole.
• Install spark plug. Do Not connect spark plug wire.
Protect Pump
To protect the pump use Sears pump saver to prevent
freeze damage and lubricate pistons and seals.
NOTE: Sears pump saver, item number 74403, is
available as an optional accessory. It is not included
with the pressure washer.
CAUTION! You must protect your unit from freezing
temperatures. Failure to do so will permanently
damage your pump and render your unit inoperable.
Freeze damage is not covered under warranty.
To use the pump saver:
_ AUTION! Read and follow all cautions and
warnings on the pump saver can label. Always
wear eye protection when using pump saver.
• Attach hose on pump saver can to pump inlet.
• Push in can top to dispense pump saver.
• When pump saver fluid begins to exit pump outlet,
the pump is protected.
• Remove pump saver from pump inlet.
OTHER
• Do Not store gasoline from one season to another.
• If possible, store your unit indoors and cover it to
give protection from dust and dirt. BE SURE TO
EMPTY THE FUEL TANK.
IMPORTANT: Never cover your pressure washer
while engine and exhaust area are warm.
14