Sears 486.24321 Spreader User Manual


  Open as PDF
of 12
 
7
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
STEP 11: (SEE FIGURE 11)
• Assembletheowcontrolmountingbrackettothe
hitch tube using two 1/4" x 1-1/2" hex bolts, four 5/16"
atwashersandtwo1/4"nylocknuts.Do not tighten
at this time.
FIGURE 11
FLOW CONTROL
MOUNTING BRACKET
1/4" x 1-1/2"
HEX BOLT
1/4" NYLOCK
NUT
5/16" FLAT
WASHER
5/16" FLAT
WASHER
STEP 12: (SEE FIGURE 12)
• Place the adjustable stop into the "ON" end of the slot
inthetopoftheowcontrolmountingbracket.Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a
5/16"atwasherandthenylonwingnut.
5/16" FLAT
WASHER
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
NYLON
WING NUT
ADJUSTABLE
STOP
FIGURE 12
STEP 13: (SEE FIGURE 13)
• Positiontheowcontrolmountingbracket.
• Pushonowcontrolarmuntilitlocksin"OFF"position.
• Slideowcontrolmountingbracketalongtubeuntil
closure plate in bottom of hopper just closes.
• Snugthe1/4"locknutsjustenoughtoholdowcontrol
mounting bracket in place.
• Setadjustablestopat"5".Pullowcontrolarmagainst
stop. Verify that closure plate has opened about half way.
• If closure plate does not open half way, it may be
closedtoofarat"OFF".Adjustpositionofowcontrol
mounting bracket until closure plate will open about
half way at "5" and still close when arm is locked in
"OFF". Tighten 1/4" lock nuts.
OFF
ON
1
2
3
4
6
7
8
9
10
5
FLOW
CONTROL
ARM
ON
OFF
AJDUSTABLE
STOP
SETTING "5"
FIGURE 13
• Before operating the spreader, pre-lubricate per the
lubrication instructions in the owner's manual.
 previous next