Sears 45-02153 Spreader User Manual


  Open as PDF
of 12
 
5
FIGURE 5
9. Placethewheel(longendofhubrst)ontotheendof
theaxlethathasnoindents.Seegure4.
10.Placea1/2"atwasherontotheaxleandthenlightly
tap a hub cap onto the axle until it is snug against the
washerandwheelhub.Seegure4.
FIGURE 4
11. Place the drive wheel onto the end of the axle that has
an indent. The long end of the hub goes to the inside.
Seegure5.
12. Place a hub cap onto the end of the axle. Using a small
hammer, lightly tap the hub cap until it is snug against
thewheel.Seegure5.
FIGURE 6
13. In order to assemble the hitch bracket to the hitch tube,
turn the spreader upright on its wheels. Assemble the
bracket to the top of the hitch using two 1/4" x 1" hex
boltsand1/4"nylocknuts.Seegure6.
FIGURE 7
1/2" FLAT
WASHER
HUB CAP
END WITH NO
CROSS HOLE
HUB CAP
FLOW CONTROL
LINK
FLOW
CONTROL
ARM
1/4" NYLOCK
NUT
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
14.Assembletheowcontrollink(endwithsmallhole)to
theowcontrolarmusinga1/4"x1"hexbolt,anylon
washeranda1/4"nylocknutasshowningure7.Tighten
carefully. Theowcontrollinkshouldnotbeloosebut
should pivot with no more than slight resistance.
1/4" x 1"
HEX BOLT
1/4" NYLOCK
NUT
HITCH PIN
HAIR COTTER PIN
 previous next