Sears 45-02153 Spreader User Manual


  Open as PDF
of 12
 
7
20. Place the adjustable stop into the "ON" end of the slot
inthetopoftheowcontrolmountingbracket.Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a 5/16"
atwasherandthenylonwingnut.Seegure12.
FIGURE 12
21.Positiontheowcontrolmountingbracket(gure13).
a. Pushonowcontrolarmuntilitlocksin"OFF"
position.
b. Slideowcontrolmountingbracketalongtubeuntil
closure plate in bottom of hopper just closes.
c. Snugthe1/4"locknutsjustenoughtoholdow
control mounting bracket in place.
d. Setadjustablestopat"5".Pullowcontrolarm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, it may be
closedtoofarat"OFF".Adjustpositionofowcontrol
mounting bracket until closure plate will open about
half way at "5" and still close when arm is locked
in "OFF". Tighten 1/4" lock nuts.
FIGURE 13
5/16" FLAT
WASHER
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
NYLON
WING NUT
ADJUSTABLE
STOP
OFF
ON
1
2
3
4
6
7
8
9
10
5
FLOW
CONTROL
ARM
ON
OFF
AJDUSTABLE
STOP
SETTING "5"
 previous next