Filter
Top Products
10
,,,,,,I,:,,,,,, i i
i i i i '111 iiii "1
E. BAR AND CHAIN I.UBRICJI.NT
• The gu_e bar u_d ¢ut1L_g¢f_n m_'im constant
lubncation to remain in opemtJng condition.
Lub_..a_n _s_ro_dedt:yme au_oma_ oiler_/_em
-- _ck of lubricant will quicker ruin the bar end
chain.
--Too little lubricant will cau,_m overheating
sm_ _ smoke co_ing from me ct_n
di._:_lon_n of 1heguidebar
• Use Seam Bar and Chain IJubdcam (#71-35554,
gaJ. or #TI-36956.qt.) Loffi! f_ olitank, Clean
3C_ oJtmay aJsobe urn, blJtisless _ Ne_
use wasm oit _ _is purpose.
• In b'ee_,ng weatller oEwillthicken, rrmidngit neees.
.saW to thin bar and chain oil with a roll amoum
of trl Diesel FueiorKemsene. _andchain oatrnu_
be _ flowing_ adeq_ lub_c_;:_n.
ii ,ii,i,i,,,i i , i
i iiiiiiiiiii iiiiiiiiiiiiiii i i • i_ i
2.HowTo FILLme oILTANK
a. Turn saw on its side wetn el| cad up. Figure
13.
b. Loosen cad Siowly;,wait forI_ressurein the
tank to be released Delete removing the
caD.
c. Fill tl_e oil tank.
d_,Replace the oil cap securely.
3, IMPO_ POIh'l_ 10 REMEMBER
& Fill _ oil tank each time yc_umfllt the rue|
tlmk to ensurethroe will be _uificient oilfor
the chain wheneveryou start anti run the
S&W.
, q.
b, 3| iS I1OtMal for • scull lmount Of oil tO ap.
[:Nllr w_r t_e lew lfllf t_ _|M S_QI:_
due to oit arainingfrom the bar a_clchain.
1. USE THE FOLLOWING:
30° or _ -- Lu_cam un_mad
30* :o 0°F. -- 95% _ tO5%
#t Dieselfuelor Ker_ene.
Below 0_F. -- 90% Lulxi¢_ to 10%
_I Ok_s_rue or Kerosene.
USING YOUR SAW
A. PRE-OPER&'nON CHECKS
Each time before operating your saw, always:
1. ,.-Check over safety ndea and lxecautions in
this manual. M_e cert_n you €ompletely
unaerstand anti can _ply earn one.
andhead pm(e_on device_:safetyfoot.at: pro*
_ec_ivegloves: ancts_ug-fittingctoming.
3..,, Chmckthesew forloomibott_ nuts.o¢fltting_
Tigman,ml:_r or re_acai=etlSas necessory.Toots
requin_ azetism_inme",em_r,Uty"
4. ,. Cl-,_kthe air _t_r. Cklanthefl_ if_tr_y,beam
sac_on.
5...Check the saw chsin. The cf_ should be Sham
and at _ corre_ tens_n. (Refer_o_e "Chain Ten-
s_n'" Section).
6. ,,.Check the fuel tlmk and oil tank. Botl_ tan_<s
should _ fil|ed.
7. _Cheek the handles. HsnctlesShOuldbe cIW
an_ tree o_fuel mixture as_ oil.
8.
g_
,_Clleek weather conditions. Do not use your
saw a_ night or €lunngb•a conait_onssuch
as strong wind. ram, snow, etc.
,.Check the work ares. Kee_ ¢_ilclren.
bys_,•n_ as,umafsa_s_fedisc;neeaway
from the work area when starting or o_eratmg
the saw -- a mtmmum of 30 teat.