Filter
Top Products
Cutting Attachment
Shield
Fuel Cap
Throttle
Control
D-Handle
Hassle-Free™ Plus
Shaft Grip
Primer Bulb
Oil Fill Plug
Cold Weather
Start Lever
Shaft
Housing
Starter Rope
Grip
Muffler
Craftsman®
Convertible™ Coupler
On/Off Stop
Control
Air Filter Cover
ADJUSTING THE D-HANDLE
1. Loosen the screws on the D-handle (Fig. 1).
2. While holding the unit in the operating position (Fig. 2), position
the D-handle to the location that provides you the best grip.
3. Tighten the clamp screws evenly, until the D-handle is secure.
Fig. 1
(4) Screws
Shaft Grip
Shaft
Housing
On/Off Stop Control
Minimum 6 Inches
(15.24 cm)
D-Handle
Bottom Clamp
Spark
Plug
KNOW YOUR UNIT
ASSEMBLY INSTRUCTIONS
INSTALL LINE TRIMMER ATTACHMENT
NOTE: To make installation easier,
place the unit on the ground or
on a workbench.
1. Turn knob counterclockwise to
loosen coupler (Fig. 16, p. 9).
2. While firmly holding attachment,
push it straight into the coupler
until the release button snaps into
the primary hole (Fig. 17, p. 9).
NOTE: Aligning the release button with
the guide recess (Fig. 17, p. 9)
will help installation.
3. Turn the knob clockwise to tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging;
and decorative trimming around trees,
fences, etc.
Line
Cutting
Blade
WARNING: DO NOT ATTEMPT TO USE THIS UNIT
UNTIL THE D-HANDLE HAS BEEN ROTATED INTO
OPERATING POSITION (Fig. 1).
Fig. 2
Trimmer
Attachment
5