Filter
Top Products
9
ASSEMBLY
5. Finish securing chute control assembly to chute support bracket
with wing nut and hex screw removed earlier. See Figure 4.
6. Check that all cables are properly routed through the cable guide
on top of the engine. See Figure 5.
7. The extension cord is fastened with a cable tie to the rear of the
auger housing for shipping purposes. Cut the cable tie and
remove it before operating the unit.
SET-UP
Shear Pins
Holes are located in the plastic dash panel for convenient shear pin
storage. See Figure 6. Refer to the Operation section for more informa-
tion regarding shear pin replacement.
Figure 4
Figure 5
Figure 6