Filter
Top Products
16
SERVICE AND MAINTENANCE
ENGINE MAINTENANCE
Checking Engine Oil
Be sure engine is upright and level
Unscrew oil fill cap from oil filler tube and wipe dipstick clean.
Screw oil fill cap back into oil filler tube. Tighten securely.
Unscrew and remove oil fill cap from oil filler tube. Note oil level.
If oil reading on dipstick is below “ADD” mark, slowly add oil to
reach “FULL” level. See Figure 12.
Screw oil fill cap back into oil filler tube. Tighten securely.
Wipe away any spilled oil.
Changing Engine Oil
To avoid engine damage, it is important to:
Check oil level before each use and every five operating hours.
Change oil after first two (2) operating hours and every 25 operat-
ing hours thereafter.
Engine should still be warm but not hot from recent use.
Locate the oil drain plug. See Figure 13.
Be sure the gas cap is on and is tightened securely.
Clean area around oil drain plug.
Place approved recyclable oil container under oil drain plug.
Remove oil drain plug and drain oil.
NOTE: Used oil must be disposed of at a proper collection center.
6. Install oil drain plug and tighten securely.
7. Refill the engine with recommended oil. See Recommended Oil
Usage chart. The engine’s oil capacity is 26 ounces.
8. Wipe away any spilled oil.
1.
2.
3.
4.
5.
6.
•
•
•
1.
2.
3.
4.
5.
Figure 12
Figure 13
FULL
ADD
Maintain Oil Level
Between FULL and ADD
-20 F
O
32 F
O
32 F
O
40 F
O
-20 C
O
20 F
O
40 C
O
30 C
O
20 C
O
10 C
O
0 C
O
-10 C
O
-30 C
O
0 F
O
60 F
O
80 F
O
100 F
O
Non-Multi Grade
SAE 30
Multi Grade
SAE 5W-30 or SAE 10W-30
Synthetic Multi Grade
SAE 0W-30
Recommended Oil Usage
WARNING
Before lubricating, repairing, or inspecting, disengage all controls
and stop engine. Wait until all moving parts have come to a complete
stop.
Oil FIll
Oil Drain