Filter
Top Products
CAUTION: IF YOU ARE REMOVING
,_ SNOW FROM ANY ROCKY OR UNEVEN
SURFACES, RAISE THE FRONT OF THE
SNOW THROWER BY MOVING THE
SKIDS DOWN. THIS WILL HELP TO PREVENT
ROCKS AND OTHER DEBRIS FROM BEING
PICKED UP AND THROWN BY THE AUGER.
TO INSTALL THE CRANK ASSEMBLY
e On the right side of the handle, install the following
(found in parts bag) in the lower hote as shown in
o
o
o
o
figure 4:
1 - 5/16" x 1-3/4" bolt
1 - 5/16" flatwasher & 5/16" Iockwasher
1 - 5/16" nut
LY
IIIllUIIlllILillllllllllllllIll _IIIllU I II J
illlll ill iilll i_ IHlll ill_l Hj i_ I I
RIGHT
51t6 INCH
LOCKWASHEB
Remove one 3/8" nut, lockwasher, and flatwasher
from the "eye" bolt assembly (on the chute crank
assembly) and place the remaining 3/8" nut and flat-
washer on the "eye" bott about half way up the thread,
as shown
5116 X 1-314 INCH BOLT
LEFT ADJUST NUTS
TO MOVE EYE
BOLT IN OR
OUT
BOOT'
Install "eye" bolt through lower hole on the left hand
side of the handle.
install the 3/8" flatwasher, the 3/8" lockwasher and
the 3/8" nut loosely on the "eye" bolt, as shown_
Remove the plastic cap, the cotter pin and the washer
from the wormed end of the crank assembly and set
® aside (See Fig. 5).
Rotate the notched section of the discharge chute
o
toward the crank-adjusting rod_
Install the wormed end of the crank through the hole
e in the adjusting rod and secure the end with the flat
washer and cotter pin, as shown.
• Bend the ends of the cotter pin around the rod and re-
install the plastic cap.
o Hold the "eye" bolt in place with a pair of pliers while
tightening the inside nut securely.
Rotate the chute crank fully clockwise and fully
counter-clockwise. The discharge chute should ro-
tate fully tothe outer diameteroi the worm and should
clear approximately 1/8" (See Fig 5)° If the chute
crank needs to be adjusted, see To Adjust Chute
Crank Assembly on page 16.
NOTE: Be sure the crank does nottouch the carburetor
cover or the cover will be scratched.
3/8 INCH FLATWASHER
FIG. 4
CAP COTTER
FLATWASHER
CRANK ADJUSTING ROD
I/2 INCH
WORM
illlllllllllllllllll
The control cables attached to the auger clutch lever and
traction clutch lever may need to be adjusted before you
use your snow thrower.
For instructions on checking or adjusting the control
cables, see To Adjust The Clutch Control Cables on
page 17.
w_ NK
EYE BOLT
ADAPTER
NOTCHED SECTION
FIG. 5
TO CHECK/ADJUST CLUTCH
CONTROL CABLES