Filter
Top Products
Service - 15
SERVICE
2. Turn oil dipstick (A) 1/4 turn counterclockwise. Remove
dipstickandwipeitwithacleancloth.
3. Install dipstick. Turn dipstick 1/4 turn clockwise and
tighten.
4. Remove dipstick. Check oil level. Oil level MUST BE
between ADD and FULL marks. If not, pour oil into dipstick
tube to bring level to FULL mark (B).
5. Install and tighten dipstick.
Changing Engine Oil
NOTE: Two different methods can be used for
changing the engine oil. Both options are acceptable
service procedures based on customer preference.
TO CHANGE ENGINE OIL FROM THE TOP:
1. Park mower on a level surface.
2. Run engine until fuel tank is empty or near empty.
3. Stop engine and disconnect spark plug wire.
4. Turn oil dipstick (A) 1/4 turn left and remove from the
filler tube.
5. Insert plastic drain tube (B) firmly inside filler tube
opening.
6. Place a drain pan on the left side of the mower.
IMPORTANT: Avoid damage! If oil level is below
the ADD mark, DO NOT run the engine.
cCAUTION: Avoid injury!
• Used oil may harm environment and people
if it is dumped on the ground or into a drain or a
body of water. Call your local Recycling Center
or authorized Scotts servicing dealer to learn
how to recycle used oil.
• Engine may be hot, use caution to avoid
burns to the hands.
MX1567
A
B
M61459
IMPORTANT: Avoid damage!
• Change oil after first 5 hours of operation.
• Change oil while engine is warm.
• If mower is not operated 25 hours during the
mowing season, change oil before storing mower.
• Help prevent air cleaner damage and hard
starting, turn mower onto the LEFT side when
servicing.
MX1567
A
B
M87111d