Filter
Top Products
2
FIGURE 2-1
3. Repeat this procedure on the opposite side.
The machine is now ready to operate.
2.3 REMOVING THE TIGER STRIPPER
The Tiger Striper can be easily removed whenever
the machine is being transported or when stripping is
not needed. To remove the Tiger Striper, follow the
instructions below.
1. Prepare the machine so there is easy and safe access
to the work area. Remove the key and maintain all
safety related work procedures. Always wear eye and
hand protection.
2. Lock the Tiger Striper up in the transport position by
lifting upward on the handle, push and turn the lock
pin 90 degrees. The small roll pin must be out of the
slot in the bracket to lock in the transport position.
See Figure 2-2.
FIGURE 2-2
3. Repeat on opposite side.
4. Once the Tiger Striper is locked in the transport
position, remove the ring pins securing the Tiger
Striper to the mounting brackets. See Figure 2-3
FIGURE 2-3
5. Slide the Tiger Striper off of the mounting
brackets.
6. To install the Tiger Striper, slide the assembly on
to the mounting brackets and reinstall the ring
pins. Once the Tiger Striper has been reinstalled,
follow Section 2.2 Operating Instructions for
proper operation.
Roll Pin
Push and
Turn Pin to
Lock
Roll Pin
Push and Turn Pin to line
up Roll Pin with Slot
to Unlock
Lift Up on
Handle
3.1 ASSEMBLY INSTRUCTIONS - STT
-NOTE-
Use the illustrated parts list as a part
number reference when following the
assembly instructions.
1. Remove all packaging materials. Lay out the
mounting hardware and the Tiger Striper assembly for
easy access.
2. Prepare the machine so there is easy and safe access
to the work area. Remove the key and maintain all
safety related work procedures. Always wear eye and
hand protection.
Remove Ring Pins