Filter
Top Products
30
R
Section 7
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
PROCEDURE COMMENTS
BREAK-IN
(FIRST 10)
8 40 100 200 500
X
Apply grease to fittings See paragraph 7.2
X
Check hardware for tightness
X
Change engine oil filter See paragraph 7.4
X
Check hydraulic oil level See paragraph 7.3
X
Replace engine fuel filter See paragraph 7.5
X
Drain hydraulic system and
replace hydraulic oil
Use SAE 20W50 Motor Oil.
See paragraph 7.3
X
Replace hydraulic oil filter See paragraph 7.3
X
Replace cutter deck gearbox
lubricant
See paragraph 7.11
X
Change coolant See paragraph 7.12
LUBRICATION7.2
GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)
LOCATION LUBRICATION INTERVAL LUBRICANT
NO. OF
PLACES
1 Caster Wheel Pivot * 500 Hours/Yearly Chassis Grease 2
2 Caster Wheel Bearings 100 Hours/Monthly Chassis Grease 2
3 Cutter Deck Bellcranks 100 Hours/Bi-Weekly Chassis Grease 4
4 Cutter Deck Pusharms 100 Hours/Bi-Weekly Chassis Grease 2
5 PTO Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 1
6 Cutter Deck Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 3
7 Brake Handle 200 Hours/MonthlY Chassis Grease 1
8 Cutter Deck Drive Shaft U-Joints 200 Hours/Monthly Chassis Grease 2
9 Cutter Deck Drive Shaft Slip Sleeve 40 Hours/Weekly Chassis Grease 1
+ Compatible Greases: Mobilix #2 found at Mobil Service Stations
Ronex MP found at Exxon Service Stations
Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
Shell Alvania #2 found at Shell Service Stations
Lidok EP #2 found at industrial shops
* Remove plug and insert grease zerk. Before filling wth grease, remove dust cap from the top of the pivot.