Filter
Top Products
3
6. Operator hearing protection is recommended,
particularly for continuous operation of the mower.
Wear suitable hearing protection. Prolonged exposure
to loud noise can cause hearing impairment or loss.
7. Keep the machine and attachments in good operating
condition. Keep all shields and safety devices in place.
If a shield, safety device or decal is defective or
damaged, repair or replace it before operating the
machine.
13. DO NOT operate without a chute deflector installed;
keep the deflector in lowest possible position.
14. Check the blade mounting bolts at frequent intervals
for proper tightness.
15. Make sure all hydraulic fluid connections are tight and
all hydraulic hoses and lines are in good condition before
starting the machine.
WARNING:
This machine is equipped with an interlock
system intended to protect the operator and
others from injury. This is accomplished by
preventing the engine from starting unless the
operator is seated in the seat, the deck drive is
disengaged, and the speed control is placed in
the neutral position. The system also shuts off
the engine if the operator leaves the seat with
the mower running and the speed control is not
in the neutral postion. It will also shut off the
engine if the hopper is raised with the cutter deck
drive engaged. Never operate equipment with
the interlock system disconnected or
malfunctioning.
8. Be sure interlock switches are functioning correctly.
9. Fuel is flammable; handle with care. Fill fuel tank
outdoors. Never fill indoors. Use a funnel or spout to
inhibit spillage. Clean up any spillage before starting
the engine.
10. DO NOT add fuel to a running or hot engine. An
explosion could occur. Allow engine to cool for several
minutes before adding fuel.
11. Keep flammable objects (cigarettes, matches, etc.), open
flames and sparks away from fthe uel tank and fuel
container.
12. Equipment must comply with the latest requirements
per ANSI J137 and/or ANSI S279 when driven on
public roads.
2.4 OPERATION CONSIDERATIONS
1. Know the function of all controls and how to stop
quickly.
2. Reduce speed and exercise extreme caution on slopes
and in sharp turns to prevent tipping or loss of control.
Be especially cautious when changing directions on
slopes.
WARNING:
DO NOT operate on steep slopes. To check a
slope, attempt to drive up it (with cutter deck
down). If machine can drive up the slope without
the wheels slipping, reduce speed and use
extreme caution. ALWAYS FOLLOW OSHA
APPROVED OPERATION.
3. Do not stop or start suddenly. WHEN GOING UP
HILL OR DOWN HILL, MOW UP AND DOWN
THE FACE OF SLOPES, NEVER ACROSS THE
FACE.
4. When using any attachment, never direct the discharge
of material toward bystanders or allow anyone near
the machine while in operation.
5. Before attempting to start the engine, disengage power
to the cutter deck and engage the parking brake.
6. If the mower discharge ever plugs, shut off the engine,
remove the ignition key, and wait for all movement to
stop before removing the obstruction. Do not use your
hand to dislodge the clogged discharge chute. Use a
stick or other device to remove clogged material.
Section 2