Filter
Top Products
30
Section 7
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
Break-In 8 40 100 200 500 Procedure Comments
(First 10)
X Apply grease to fittings See paragraph 7.2
X Check hardware for tightness
X Change engine oil filter See paragraph 7.4
X Check hydraulic oil level See paragraph 7.3
X Replace engine fuel filter See paragraph 7.5
X Drain hydraulic system and See paragraph 7.3
replace hydraulic oil Use SAE 20W50
Motor Oil
X Replace hydraulic oil filter See paragraph 7.3
X Replace transmission gearbox See paragraph 7.12
lubricant
X Replace lubricant in cutter deck See paragraph 7.13
gear boxes
* Perform these maintenance procedures more frequently under extreme dusty or dirty conditions
7.2 LUBRICATION
GREASE FITTING LUBRICATION CHART
(SEE FIGURE 7-1)
LUBRICATION NO. OF
LOCATION INTERVAL LUBRICANT PLACES
1. Drive Shaft Mtg. Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 1
2 Blower Bearings 8 Hours/Daily +Lithium MP White Grease 2125 1
3 Caster Wheel Pivot 100 Hours/Bi-Weekly Chassis Grease 2
4 Caster Wheel Bearings 100 Hours/Bi-Weekly Chassis Grease 2
5 Cutter Deck Push Arms 100 Hours/Bi-Weekly Chassis Grease 2
6 Rear Wheel Pivot 100 Hours/Bi-Weekly Chassis Grease 1
7 Rear Wheel Bearings 100 Hours/Bi-Weekly Chassis Grease 1
8 Hopper Discharge Pivot 100 Hours/Bi-Weekly Chassis Grease 1
9 Cutter Deck Drive Shaft 100 Hours/Bi-Weekly Chassis Grease 3
10 Steering Control Levers and Linkage 100 Hours/Bi-Weekly Chassis Grease 6
11 Speed Control Levers 100 Hours/Bi-Weekly Chassis Grease 2
12 Engine Belt Idler Arm 200 Hours/Monthly Chassis Grease 1
13 Blower Belt Idler Arm 200 Hours/Monthly Chassis Grease 1
14 Blower Gate Lever 200 Hours/Monthly Chassis Grease 1