Filter
Top Products
34
R
Section 7
5/8-11 x 1-1/2" HEX HEAD BOLT
TORQUE TO 75 FT/LBS
LOCKWASHER
FLATWASHER
CUTTER BLADE
Blade ReplacementFigure 7-9.
- NOTE -
Be sure that the blade is installed with the lift wing
toward the top.
Install the cutter blade onto the cutter spindle shaft. 5.
Secure the blades from rotating and torque to 75 ft/
lbs. See Figure 7-9.
TIRES7.9
Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels 25 PSI
Drive Wheels 8 PSI
BODY, DECK, AND UPHOLSTERY7.10
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
After each use, wash the mower and cutter deck. 1.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
Do not spray electrical components.
2.
Use a mild soap solution or a vinyl/rubber cleaner to 3.
clean the seat.
Repair damaged metal surfaces using Scag touch-4.
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.