Saunatec IG-570G Hot Tub User Manual


 
IG-570G-1 9 25/10/2007
WARNINGS AND SUGGESTIONS FOR USE
Please read carefully the following warnings, to reduce the risk of burns, fire, electric shock, or
injury to persons:
Do not put the sauna room in a moist environment.
Place room on level surface.
Do not repair the product by yourself. Contact the Saunatec National Customer Service
Center toll-free at 1-888-780-4427, or email at techsupport@saunatec.com.
Do not disassemble the product by yourself except as indicated in the manual.
Do not spray the heater with water.
Do not use any sharp tools on or near the heaters (severe damage may result).
Do not use the product for any other purpose than originally designed and intended.
Do not directly touch the heater with hands or body for extended periods of time.
Do not use continuously for more than one hour.
SUGGESTIONS FOR USE
When enjoying a sauna room bath, it is suggested to turn power on at least 15 minutes
beforehand. After 15 minutes of preheating, the temperature inside the sauna room should
reach about 105 degrees F (40°C) ; at this stage most people find the sauna a comfortable
temperature to begin the sauna bath. The temperature will continue to rise to the set
temperature.
If it feels too hot during use, adjust the temperature down, open the vent or open the door
for fresh air.
CLEANING
Clean the outside and inside with a damp cloth, or clean with a small amount of hand-soap
mixed with warm water if necessary. Do not use benzene, alcohol, or strong cleaning chemicals
on sauna.
Note: Some chemicals can damage wood material and the protection layer that is on the outside
wood surface.
STORAGE
Do not store product in a moist environment or in direct sunlight.
SPECIFICATION
Product Name Infrared Wooden Sauna Room
Product No. IG-570G
Product Size
126×64.7/89.7/64.7×190(H)cm(
49.6“
×
25.5“/35.3“/25.5“
×
74.8“
)
Weight ca. 175 kg
Power Supply AC120V
Power Consumption 1620W
Wooden Material Canadian Hemlock