Filter
Top Products
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, make sure on/off switch is in off
(0) position before plugging in.
NOTE: Features may vary by model yet all parts assemble
the same.
HOW TO ASSEMBLE
Attach Handle
CAUTION: Do not catch cord under handle.
1. From rear of cleaner, align handle with groove and slide
onto cleaner. If necessary, use thumb and finger pressure
to slide handle into position.
2. Attach handle with the two 1 inch screws provided in the
assembly packet. Use a Phillips
®
head screwdriver.
NOTE: Hand tighten with screwdriver to be sure both
screws are firmly seated.
3. Pick up hose and lay across upper hose retainer.
4. Push the end of the hose in the lower hose retainer to
secure.
4
Lower Hose Retainer
Hose
Upper Hose
Retainer
3
Attach Hose
Store Hose and Accessories
Nested Wands
Dusting
Brush
Store Electrical Cord
5. You will find your cord retainer on the handle above the
upper cord hook. Firmly push the electrical cord down into
the cord retainer. This will place the cord out of the way the
next time you vacuum.
6. Next wind the cord around the two cord hooks on the back
side of cleaner.
7. Secure the plug to the cord to prevent unwinding.
8. For quick and easy cord removal, the upper cord hook
swivels.
Cord
Retainer
5
Cord Hook
6
Plug7
Cord Hook
6
Grooves
1
2
6