Filter
Top Products
11
ATTACHING THE FRONT HANDLE − CS30 AND
SS30
See Figure 4.
Remove 2 wing nuts, 2 bolts, and clamp from the front
handle.
Install the front handle onto the top side of the drive shaft
housing and move it to a comfortable position.
Place the bolts through the front handle.
NOTE: The hex bolt head fits inside the hex recess molded
into one side of the handle.
Reinstall the clamp, bolts, and wing nuts.
Tighten wing nut securely.
ATTACHING THE “J” HANDLE − BC30
See Figure 5.
A “J” handle must be used for ensuring the best control and
maximizing operator safety when using a brushcutter.
Hold the top and bottom clamp snugly in position on
the shaft housing so that handle will be located to the
operator’s left.
Insert the end of the handle between the clamps.
Align the bolt holes and push the long bolt (1/4-20 x
1-1/2 in.) through the handle side.
Place short bolt (1/4-20 x 1 in.) through opposite side of
clamp. Install flat washers, lock washers, and hex nuts
to hold the assembly in place.
After assembly is complete, adjust the position of the
handle for best balance and comfort.
Tighten the long bolt first and then the short bolt.
ASSEMBLY
WING
NUT
FRONT HANDLE
BOLT
Fig. 4
Fig. 5
CLAMP
FLAT WASHER
LOCK WASHER
HEX NUT
STRAP
HANGER
BOLT
1/4-20 x 1-1/2 in.
CLAMP
FRONT
HANDLE
BOLT
1/4-20 x 1 in.
CLAMP