Filter
Top Products
8
ATTACHING THE HANDLE
See Figure 4.
A barrier handle should be used for ensuring the best
control and maximising operator safety.
1. Place the handle base and the bracket on the shaft
housing below the spacer.
2. Install the two handle base screws and nuts, but do not
tighten completely.
3. Place the front handle grip onto the handle base and
install the two screws. Tighten securely.
4. Adjust the position of the front handle for best balance
and comfort.
5. Tighten the two handle base screws securely.
NOTE: Do not attempt to remove or modify the spacer.
This spacer limits the upper position of the handle grip.
See Figure 4.
ASSEMBLY
Fig. 4
HANDLE
BASE
BRACKET
HANDLE BASE
SCREWS
NUTS
FRONT HANDLE GRIP
SCREWS
SPACER
SPACER
STRAP HANGER
HANDLE
BARRIER
BAR