Filter
Top Products
8 9
Fig. 2
CLAMP
FLAT WASHER
LOCK WASHER
LONG BOLT
CLAMP
SHORT BOLT
“J” BARRIER
HANDLE
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING THE “J” BARRIER HANDLE
See Figure 2.
n Hold the top and bottom clamp snugly in position on the
shaft housing so that the handle will be located to the
operator’s left.
n Insert the end of the handle between the clamps.
n Align the bolt holes and push the long bolt (1/4-20 x
1-1/2 in.) through the handle side.
n Place short bolt (1/4-20 x 1 in.) through opposite side of
the clamp. Install the flat washer, lock washers, and hex
nuts to hold the assembly in place.
n After assembly is complete, adjust the position of the
handle for best balance and comfort.
n Tighten the long bolt first and then the short bolt.
UNPACKING
This product requires assembly.
n Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Power Head Assembly
Pruner Attachment
Scabbard
Scrench (5/8 in. x 3/4 in.)
8 oz. Bar and Chain Oil
Bottle of 2-cycle oil
Shoulder Strap Bracket
Shoulder Strap
“J” Barrier Handle Assembly:
“J” Barrier Handle
Top and Bottom Clamp
Short Bolt
Long Bolt
2 Flat Washers
2 Lock Washers
2 Bolts
Operator’s Manual
Warranty Registration Card
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to heed this warning
could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
ASSEMBLY
HEX NUT
INSTALLING THE SHOULDER STRAP
See Figure 3.
The shoulder strap provides added support of the pruner
during operation.
To install the shoulder strap bracket:
n Remove the hex nut, lock washer, and bolt from the
shoulder strap bracket.