Filter
Top Products
14 15
ST
OP
MAINTENANCE
CHAIN OILER
See Figure 22.
n Use Premium Bar and Chain Oil. It is designed for chains
and chain oilers and is formulated to perform over a wide
temperature range with no dilution required.
n Remove the cap and carefully pour approximately 8 oz.
of bar and chain oil into the chain oiler tank.
n Replace the cap and tighten securely.
n Check and refill the chain oiler tank every time the engine
is fueled.
NOTE: Do not use dirty, used or otherwise contaminated
oils. Damage may occur to the oil pump, bar, or chain.
Fig. 22
REMOVE
CAP
REPLACE
CAP
CHAIN OILER TANK
IDLE SPEED ADJUSTMENT
See Figure 21.
If the chain turns at idle, the idle speed screw needs ad-
justing on your trimmer engine. Turn the idle speed screw
counterclockwise to reduce the idle RPM and stop the chain
movement. If the saw chain still moves at idle speed, contact
a service dealer for adjustment and discontinue use until the
repair is made.
WARNING:
The saw chain should never turn at idle. Turn the idle
speed screw counterclockwise to reduce the idle RPM
and stop the chain, or contact a service dealer for ad-
justment and discontinue use until the repair is made.
Serious personal injury may result from the saw chain
turning at idle.
IDLE
SPEED SCREW
Fig. 21