Filter
Top Products
Page 13 — English
CONNECTING TO POWER SUPPLY
See Figure 5.
This product is designed with a cord retainer that
prevents the extension cord from being pulled
loose while using.
Form a loop with the end of the extension
cord.
Insert loop portion of extension cord through
opening in the bottom of the rear handle and
place over cord retainer.
Slowly pull loop against cord retainer until the
slack is removed.
Plug product into extension cord.
NOTE: Failure to remove all excess cord slack
from extension cord retainer could result in plug
loosening from receptacle.
STARTING AND STOPPING
See Figure 5.
To start the motor:
Connect the pole saw to power supply.
Place your thumb on the lock-out button and
pull it completely towards you.
Fully depress the switch trigger.
To stop the motor:
Release the switch trigger.
Fig. 5
LOCK-OUT
BUTTON
SWITCH TRIGGER
CORD RETAINER
ADJUSTING TELESCOPING POLE
See Figure 6.
Disconnect the pole saw from the power sup-
ply.
Rotate the collar counterclockwise to loosen.
Push poles towards each other to shorten the
pole or pull away from each other to lengthen
the pole.
NOTE: Extend the pole only to the length
required to reach the limb being cut. Do not
extend the handle above waist height.
When the desired length is achieved, rotate the
collar clockwise to secure.
NOTE: Adjust hand placement on the shaft of the
pole saw to keep proper balance. Do not attempt
to use the pole saw at a length which does not
allow you to achieve proper footing and balance
at all times.
OPERATION