Filter
Top Products
20 - English
REPLACING BAR AND CHAIN
See Figures 23 - 27.
WARNING:
Remove the battery pack from the chain saw
and make sure the chain has stopped before
you do any work on the saw. Failure to do so
may result in accidental starting and possible
serious injury.
WARNING:
The safety instructions in this section are to
protect the user from serious personal injury.
CAUTION:
Always wear gloves when handling the bar and
chain; these components are sharp and may
contain burrs.
WARNING:
Never touch or adjust the chain while the motor
is running. The saw chain is very sharp; always
wear protective gloves when performing main-
tenance to the chain to avoid possible serious
lacerations.
Remove the battery pack before you do any
work on the chain saw.
Remove the hex key from the storage area and
use it to remove the chain cover screw, washer
and chain cover from the chain saw.
Remove the bar and chain from mounting surface.
Remove the old chain from the bar.
Lay out the new saw chain in a loop and
straighten any kinks. The cutters should face in
the direction of chain rotation. If they face the
opposite direction, turn the loop over.
Place the chain drive links into the bar groove.
Position the chain so there is a loop at the back of
the bar. Hold the chain in position on the bar and
place the loop around the sprocket of the chain
saw. Fit the bar flush against the mounting surface
so that the bar stud is in the long slot of the bar.
NOTE: When placing the bar on the bar stud,
assure that the adjusting pin is in the chain ten-
sion pin hole.
MAINTENANCE
RECOMMENDED BAR AND CHAIN
COMBINATIONS
Bar Part Number - 10 in.
671256002 or 671834007
Chain Part Number
6958301 or 690583002
Fig. 23
Fig. 24
Fig. 25
CHAIN
TENSIONING
SCREw
BAR
GROOvE
CHAIN DRIvE
LINKS
ADjUSTING
PIN
BAR
wASHER
CHAIN
COvER
SCREw
CHAIN
COvER
CHAIN
CHAIN TENSION
PIN HOLE
SPROCKET