Subaru Robin Power Products RGV12100 Portable Generator User Manual


 
42
9-5 REAR COVER
(1) Put the rear cover with stator and stator
cover over the rotor.
Pull wires out from the rear cover.
NOTE : Be careful not to give cuts to wires when
pulling them out from the rear cover.
Attach the bushing over the lead wire
drawn out from the rear cover.
Press the smaller end of the bushing into
the window of the rear cover.
(2) Tap on the rear cover evenly with a plastic
hammer to press the rotor bearing into
the rear cover.
(3) Fix the rear cover with four bolts, spring
washers, and washers.
(4) Install the brush holders in the rear cover.
Pass the mounting screws through the
brush holders, push the brush holders so
that the brushes will be perpendicular to
the slip rings, and tighten the screws.
NOTE : There are two kinds of brush holders.
If a brush is installed oblique to the
slip ring, the brush holder can break
when the screw is tightened ; or the
brush may break when the generator
of started.After installing the brush
holders, measure the resistances
across the brushes and terminals
with a tester if they are from 5 ohms
to 7.5 ohms.If so, the brush holders
are correctly mounted.
BRUSH
COVER
BRUSH
HOLDER
FLANGE
BOLT
SCREW
Fig. 9-9
Fig. 9-10
Fig. 9-11
Tightening torque
120
-
140 kg cm
11.8
-
13.7 N m
8.7
-
10.1 ft lbs