Filter
Top Products
After you have entered the preset times, start your Training Timers by pressing “A”. The
timers will sequence through each channel, with an audible beep signaling the end of the
previous segment. You may skip channels if no time value is entered. For instance, if
you have times input in channels 3, 5, 6 and 9, the SC-848W will go from one to the next
and ignore 1,2,4,7 and 8.
Times may be preset from one second to 100 hours.
PART 5- CHRONOGRAPH (STOPWATCH) OPERATION
From NORMAL TIME, press “E” three times to enter the CHRONO mode. STW, LAP,
STOP and SPLIT indicators appear.
The “stopped” chronograph (stopwatch) display will appear as shown above. If not,
press “A” to stop and “B” for 2-3 seconds to reset the display to all zeros.
The working range of the chronograph is one hundred hours, with a resolution of 1/100
second. The chronograph measures lap and split time, simultaneously. You may set
Row 3 to present either running Lap or running Split (accumulated) time.
(NOTE: You cannot operate the chronograph when the speed timer is not reset to
all zeros. To stop the speed timer, enter the speed mode. Stop timing by pressing “A”
once. Press “B” for two seconds until the timer is reset to all zeros. Once the speed timer
is stopped, you may enter and use the chronograph.)
Select Lap or Split in Row 3:
While the chronograph is reset to all zeros, press and hold “B”. LAP or SPL indicator
will appear flashing. Select between LAP and SPLIT by pressing “B”.
Selecting SPLIT will cause the timer to display the accumulated running time from the
start of the event in Row 3.
Select Recall Up or Down
While the chronograph is reset to all zeros, select Memory recall as Ascending
(1,2,3,…300) or Descending (300,299,298…3,2,1) order by pressing “F”. When
Descending is selected, the down arrow (▼) will appear. If Ascending is selected, the
down arrow will disappear.
Timing Single Lap Events
[000]
00:00’00”00
00:00’00”00
00:00’00”00
CHRONO