Filter
Top Products
value appears. Once set, move to the second digit by pressing “B”. Change the second
digit by pressing “A”.
Continue to set each digit on the distance scale until you have entered the correct
distance. Press “F” to exit the distance setting process. The distance set will appear in
the middle row without any digits flashing.
NOTES:
(1) Should you need to set any particular digit on the distance scale, press “F” until SET
“mile” or “km” appears flashing. Then press “B” until the correct digit appears flashing.
Change the digit(s) by pressing “A”. To exit the setting procedure, press “F”
(2) The maximum setting distance is 999.999 miles or kilometers.
(3) The speed timer will not work unless a distance has been entered.
Select Recall Up or Down
While the Speed Timer is reset to all zeros, select Memory recall as Ascending (1,
2,3,…300) or Descending (300,299,298…3,2,1) order by pressing “F”. When
Descending is selected the down arrow (▼) will appear. If Ascending is selected, the
down arrow will disappear.
One Lap Event (START/STOP/RESET)
START: Press “A” to start the timer. RUN and LAP indicators appear. Time appears
running in Row 3.
STOP: Press “A” again to stop the timer. The “Stop” indicator appears.
RESET (all zeros): To return the timer to the start position, press “B” for 2 seconds.
IMPORTANT NOTICE--- “ERROR” INDICATOR
When taking a speed reading and ERROR appears in the middle row, you have exceeded
the speed capacity of the timer (999.999 mph/kph).
This occurs when you take a lap reading too soon, either by accident or on purpose, i.e.
long distance and fast lap time. When this situation occurs, your timer is functioning
properly and is still recording data. Wait until the lap is completed, then press “B” and
the appropriate lap speed and time will appear on the display.
Multiple Lap Event Timing
When timing multiple lap events, the operating sequence is: START - LAP - STOP -
RESET.
START: Press “A” to start. STW and LAP indicators appear and the time appears
running in Row 3.
LAP: To take a lap reading, press “B” the instant the lap is completed. SPEED indicator
appears. The lap number and time appear in Row 1, the lap speed in Row 2. The current